How to start your VK?
1 begin by refueling your motorcycle with #87 regular gas
2 squeeze the carburetor primer bulb a few times to remove air until there is no air bubble visible in the fuel line.
(click the photo to view lager)
3 turn off the choke lever
(click the photo to view lager)
4 secure the kill switch, make sure it is connected to the bike tightly
5 hold the brake
it is highly recommended that the brake shall be held when starting the bike
(click the photo to view lager)
6
Gently pull the cord of the pull starter, while holding the brake
when you will the resistance, pull the cord slightly harder, and the engine will be started
DO NOT PULL THE CORD OUT COMPLETELY!
7
After the engine started for a few seconds,
Locate the throttle grip on the right handlebar, rotate it slightly to give a small amount of throttle.
and ride with the choke lever "ON"
(click the photo to view lager)