TABLE OF CONTENTS

• Intructions
  • Step 1
  • Step 2
  • Step 3
  • Step 4
  • Step 5
  • Step 6
  • Step 7
• Products applied to

Instructions

Step 1

Begin by refueling your motorcycle with #87 regular gas

Step 2

Squeeze the carburetor primer bulb a few times to remove air until there is no air bubble visible in the fuel line.

MT-7, the bulb is at the right side of the bike

MT-6, the bulb is at the right side of the bike

MT-2, the bulb is at the right side of the bike

GK-49A, the bulb is behind the gas lines at the left side of the bike

(click the photo to view lager)

Step 3

Secure the kill switch, make sure it is connected to the bike tightly

Step 4

Put down the choke lever, before pull the cord of the pull starter

Step 5

Hold the brake

it is highly recommended that the brake shall be held when starting the bike

(click the photo to view lager)

Step 6

Gently pull the cord of the pull starter

when you will the resistance, pull the cord slightly harder, and the engine will be started

DO NOT PULL THE CORD OUT COMPLETELY!

Step 7

After the engine started for a few seconds,  pull up the choke lever

rid your bike withe the choke lever "UP"

MT-2 choke lever

MT-6 choke lever

MT-7 choke lever

GK-49A choke lever

Products applied to

this instruction applicable to those models:

MT-1

MT-2

MT-3

MT-6

MT-7

GK-49A