Applied to products:

PAD50-1

PAD50-2

PAD50-3

PAD50-8

PPB50-1P

PPB50-1ES



Video 1: Change a pull starter without a shell


Tools Required:

A pull starter

#2 Phillips head screwdriver


Instructions:

1. Remove the 4 screws on the pull start housing then remove pull start


2. Install the new starter

  • DO NOT PRESS ON THE FINS

  • Pull the handle slightly to align the gears

  • Align the holes and re-install 4 phillips head screws

3. Start!

*remember always pull with a steady even pull rather than a jerking motion to avoid future issues with the pull starting system.



Video 2: Replacing a Pull Starter with a Shell



Instructions:

1 Remove the pull starter Remove the 3 screws on the pull start housing then remove pull start 

2 Assemble the new pull starter 

DO NOT PRESS PULL STARTER GEARS ON THE FINS OF FLYWHEEL 

Pull the handle slightly to align the gears 

Align the holes 

Re-install 4 phillips head screws 

*remember always pull with a steady even pull rather than a jerking motion to avoid future issues with the pull starting system.